ADWORKS Electrical & Electronics Toolkit

Electrical Design Panel / Breaker Schedule Electronics Diagnostics Repair Records

Power / Current Calculator

Voltage (V)

Current (A)

Power (W)

Enter any two values.

Energy Consumption

Load (W)

Hours/day

Days

Voltage Drop Estimate

Preliminary copper-conductor estimate only. Final conductor size must be verified against applicable code, ampacity, installation method, temperature, grouping, voltage drop limits, and actual equipment requirements.

System

Current (A)

One-way length (m)

Copper size (mm²)

System voltage

Ohm's Law

Voltage (V)

Current (A)

Resistance (Ω)

Enter any two values.

Technician Quick Notes

Equipment / Brand

Model

Error / Symptom

Checks / Findings / Parts

Date	Equipment	Model	Symptom	Notes

Electrical Load & Feeder Planning

Planning assistant for preliminary load schedules and feeder documentation. Final breaker, conductor, grounding, fault-current and protection selection must be verified by a qualified electrical professional using actual equipment data and applicable code.

Supply Voltage (V)

Design Load (W)

Power Factor

Phase

Continuous Load?

One-way Run (m)

Important: The tool reports calculated/design current and voltage-drop targets, but intentionally does not declare a final legal wire or breaker size. Ampacity depends on conductor material/insulation, temperature, bundling, raceway, terminals, installation method, motor/inrush characteristics and local code.

Distribution Panel / Breaker Schedule Designer

Create a professional circuit schedule and simple one-line concept for quotations, site surveys and handover documents.

Circuit / Load

Load (W)

Voltage (V)

Phase / Pole

Area / Location

Notes

#	Circuit / Load	Area	W	Calculated A	Pole	Proposed Breaker	Proposed Wire	Notes

“Proposed Breaker” and “Proposed Wire” are editable documentation fields for the technician/engineer to fill after verification.

UTILITY / SOURCE

MAIN DISCONNECT
+ PROTECTION

DISTRIBUTION PANEL

BRANCH CIRCUITS

LOADS

Electronics Diagnostic Workbench

Useful for TV, aircon control boards, washing machines, power supplies, appliances and general electronics repair. It organizes diagnosis; it does not replace manufacturer service information.

Resistor Helper

Resistance (Ω)Applied Voltage (V)

LED Series Resistor

Supply VLED Forward VTarget Current mA

Capacitor Energy

Capacitance µFVoltage V

Power Supply Check

Rated Output VMeasured Output V

Symptom → Diagnostic Checklist

Equipment Type

Symptom

Error Code / Detail

For mains-powered or high-energy equipment: disconnect/isolate before resistance/continuity work, discharge energy-storage components safely, and use manufacturer-approved procedures. Error-code meanings are brand/model-specific and should not be invented.

Repair Job & Parts Record

Customer Name

Mobile / Contact

Job Reference

Customer Address

Equipment / Brand / Model

Serial No.

Complaint

Diagnosis

Parts Replaced

Parts Cost

Labor / Service Fee

Warranty Days

Inventory Usage (optional)

Connected workflow: Saving a repair record also queues it for Customer CRM, Job Order, Receivables, Project Profit, Warranty/Service, and Materials Inventory. Open those modules to complete the sync on this device.

Date	Customer/Job	Equipment	Complaint	Diagnosis	Parts	Total	Warranty

Safety Reminder

This toolkit provides preliminary calculations and record-keeping support. Isolate equipment, verify absence of voltage, use correct PPE and instruments, and follow manufacturer instructions and applicable electrical rules. Do not bypass protective devices or perform hazardous live testing.